Remington Titanium-X Foil Shaver F5800 Mode D'emploi page 3

ENGLISH
CORDED USE
• Connect the shaver to the adaptor, then to the mains and recharge for 5 minutes before
using.
A CAUTION
Extended mains only use will result in the reduction of the battery life.
HOW TO USE
,
SHAVING
• Make sure your shaver is properly charged
• Switch the shaver on.
• Stretch the skin with your free hand so the hairs stand upright
• Hold the shaving head so that the foils touch your face
• Use short, circular strokes.
,
TRIMMING
• While your shaver is switched on, slide the on/off switch upwards to activate the
trimmer.
• Push the trimmer release button.
• Hold the trimmer at a right angle to your skin
• To retract the trimmer push the top rear of the trimmer downward until it locks under
the trimmer release button.
Tips for best results
E
• Ensure your skin is dry. Always hold the shaver at right angles to the skin so that all three
heads are touching the skin with equal pressure.
• Use moderate to slow stroking movements. The use of short circular motions in stubborn
areas may obtain a closer shave, especially along the neck and chin line.
• DO NOT press hard against the skin in order to avoid damage to the foil.
C CARE FOR YOUR SHAVER
• Care for your appliance to ensure a long lasting performance.
• We recommend you clean your appliance after each use.
• The easiest and the most hygienic way to clean the appliance is by rinsing the appliance
head after use with warm water.
• Keep the trimmer in the "off" position when the shaver is not in use.
C DRY CLEANING
• Ensure the shaver is switched off and unplugged from the mains outlet.
• Pull the foil assembly up to remove from hair pocket.
• Thoroughly blow out the stubble from the foils and cutters.
• Tap out excess hair shavings and use a cleaning brush if necessary.
• Do not clean the shaving foil with a brush.
4
ENGLISH
• Replace head assembly.
C WASHABLE CLEANING
• Ensure the shaver is switched off and unplugged from the mains outlet.
• Pull the foil assembly up to remove from hair pocket.
• Foils – do not use the brush to clean the foils. Instead, blow the shavings out or rinse the
foils under cold water or warm water.
• Cutters & Trimmers – Use the cleaning brush to sweep any loose hairs from the cutter
and trimmer. Rinse them in cold or warm water. Do not use hot water.
• After cleaning, replace the head assembly.
• Replace head assembly.
A CAUTION
Never submerge your shaver completely under water.
C TRIMMER
Lubricate the teeth of the trimmer every six months with one drop of sewing machine oil.
,
REPLACING THE FOILS & CUTTERS
To ensure the continued highest quality performance from your shaver, we recommend that
foils and cutters are replaced regularly.
,
SIGNS THAT YOUR FOILS AND CUTTERS NEED REPLACING:
Irritation: As foils get worn, you may experience skin irritation.
Pulling: As the cutters wear, your shave may not feel as close and you may feel your cutter
pulling your hair.
Wear through: You may notice that the cutters have worn through the foils.
,
TO REPLACE THE FOIL
• Pull the foil assembly up to remove from the hair pocket.
• Insert new foil assembly in hair pocket until it snaps into place.
,
TO REPLACE THE CUTTERS
• Grasp cutter between thumb and forefinger and pull forward.
• Snap both new cutter assemblies into top of oscillator tips.
DO NOT press on the cutter ends as this may cause damage.
Rotary heads replacement model: SPF-300
5