LD Systems LAX12DA Manuel D'utilisation page 15

PRESET SELECTOR
40
The preset selector is used to select the desired effect. There is a total of 100 effects presets available: Echo,
vocal, plate and various effects combinations (two effects each). Once you have found the correct preset,
simply confirm the selection by pressing the preset selector.
PEAK/MUTE LED
41
If this LED lights up, this means that the input signal is exceeding the clipping threshold (i.e., is too strong). If
the LED is illuminated constantly, the effects module is deactivated.
43 45
PHANTOM
FOOT SW
POWER
AC INPUT
ON
AC INPUT
210-240V 50Hz
EUROPE
Fuse:T6.3AL 250V
RATED POWER
CONSUMPTION: 1150W
OFF
44
42
POWER SWITCH
42
This switch is used to turn the mixer ON or OFF.
PHANTOM SWITCH
43
that the phantom power is off before connecting microphones.
AC INPUT
44
This socket is used to connect the power cord.
FOOT SW
45
This socket can be used to connect an external footswitch for activation/deactivation of the integral effects
SPEAKER OUTPUTS
46
These are used to connect the speakers via which the output signal of the integral amplifier is output
CLASS 2 WIRING
400 W @ 4 OHM
STEREO MODE:
£
RIGHT
46
CONTROL ELEMENTS:
250 W @ 8 OHM
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING: SHOCK HAZARD
- DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE
CAUTION:
REPLACE WITH THE SAME TYPE FUSE AND RATING
DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE
LEFT
- NE PAS OUVRIR
MODEL
SERIAL
15