Black & Decker BDH1600PL Mode D'emploi page 3

Masquer les pouces Voir aussi pour BDH1600PL:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

with mild soap and water. If battery liquid gets into the eye, rinse water over the
open eye for 15 minutes or until irritation ceases. If medical attention is needed, the
battery electrolyte for Lithium Ion batteries is composed of a mixture of liquid organic
carbonates and lithium salts.
WARNING:
sometimes there is a possibility of small debris being discharged from the air vents, especially
after cleaning / replacement of the filters as debris inside the unit can be disturbed.
• The charger supplied with this product is intended to be plugged in such that it is
correctly orientated in a vertical or floor mount position.
SAFETY WARNINGS AND INSTRUCTIONS: BATTERIES
• Do not disassemble or open, drop (mechanical abuse), crush, bend or deform,
puncture, or shred.
• Do not modify or remanufacture, attempt to insert foreign objects into the battery,
immerse or expose to water or other liquids, or expose to fire, excessive heat including
soldering irons, or put in microwave oven.
• Only use the battery / tool with a charging system specified by the manufacturer/supplier.
• Do not short-circuit a battery or allow metallic or conductive objects to contact both
battery terminals simultaneously.
• Dispose of used batteries promptly according to the manufacturer/supplier's instructions.
• Improper battery use may result in a fire, explosion, or other hazard.
• Battery / tool usage by children should be supervised.
SAFETY WARNINGS AND INSTRUCTIONS: CHARGING
1 . This manual contains important safety and operating instructions.
2. Before using battery charger, read all instructions and cautionary warnings on battery
charger and product using battery.
charger only with this product. Batteries in other products may burst causing
personal injury or damage.
3. Do not expose charger to rain or snow.
4. Use of an attachment not recommended or sold by BLACK+DECKER may result in a
risk of fire, electric shock, or injury to persons.
5. To reduce risk of damage to electric plug and cord, pull by plug rather than cord
when disconnecting charger.
6. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise
subjected to damage or stress.
7. An extension cord should not be used unless absolutely necessary. Use of improper
extension cord could result in a risk of fire, electric shock or electrocution.
8. Use only the supplied charger when charging your tool. The use of any other charger
could damage the tool or create a hazardous condition.
9. Use only one charger when charging.
10. Do not attempt to open the charger. There are no customer serviceable parts inside.
Return to any authorized BLACK+DECKER service center.
11. DO NOT incinerate the tool or batteries even if they are severely damaged or
completely worn out. The batteries can explode in a fire. Toxic fumes and materials
are created when lithium ion battery packs are burned.
12. Do not charge or use battery in explosive atmospheres, such as in the presence of
flammable liquids, gases or dust. Inserting or removing the battery from the charger
may ignite the dust or fumes.
13. If battery contents come into contact with the skin, immediately wash area with mild
soap and water. If battery liquid gets into the eye, rinse water over the open eye for
three minutes or until irritation ceases. If medical attention is needed, the battery
electrolyte is composed of a mixture of liquid organic carbonates and lithium salts.
SAVE THESE INSTRUCTIONS
SYMBOLS
• The label on your tool may include the following symbols. The symbols and their definitions are as follows:
V ..................volts
Hz ................hertz
min ..............minutes
or DC ..direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)
Do not look into the air vents when the unit is switched on, as
CAUTION: To reduce the risk of injury, use this
A ...................amperes
W ..................watts
n o .................no load speed
.../min or rpm ........ revolutions or reciprocation
3
or AC .......alternating current
.................earthing terminal
................safety alert symbol
per minute

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Bdh1800plBdh2000pl

Table des Matières