Side view
•
Audio Jack (1)
•
Wi-Fi Protected Setup™ Button (2)—Use Wi-Fi Protected Setup to automatically and
securely add compatible wireless devices to your network. Refer to Using Wi-Fi Protected
Setup on page 12.
•
Reset Button (3)—Press and hold until the power light on the front of the range extender
blinks to reset to factory defaults. You can also restore the defaults from the
Administration > Factory Defaults screen in the extender's settings interface (page 10).
Bottom view
•
Ethernet—Connect wired devices to your wireless network with Ethernet (network)
cables. The green light turns on when an Ethernet device is connected and active on this
port. The light blinks when the extender is sending or receiving data over the Ethernet port.
How to Install the Range Extender
1. Plug in the range extender
4