Gps Locator; Introduction Of Gps Locator Operation; Setting The Destination - Pioneer AVG-VDP1 Mode D'emploi

Section
06

GPS Locator

Introduction of GPS locator
operation
WARNING
The GPS Locator functionality utilizes the
GPS and Gyrosensor in the AVG-VDP1 to
provide information about your current loca-
tion. It is not intended to be any kind of gui-
dance or navigation device.
GPS locator lets you know the current location
of your vehicle by combining GPS and gyro-
sensor. The current location is shown by the
longitude and latitude. In addition, GPS loca-
tor can show the straight distance and the di-
rection between the destination and the
current location.
1 Function display
Shows the GPS locator function names.
% Touch Menu.
The function names are displayed.
# When Menu is not displayed, you can display
it by touching the screen.
# To return to the previous display, touch Back.
# To return to the normal display of each mode,
touch ESC.
20
En
1

Setting the destination

You can set the destination by specifying the
longitude/latitude and by selecting from a
stored location in the address book.
Setting the destination by
specifying longitude and latitude
! This unit uses WGS 84 of the world geode-
tic system. (Refer to page 33.)
1 Touch Menu and Destination Menu and
then touch LON./LAT.
2 Enter longitude and latitude of the des-
tination.
! LON.  Touch to enter the longitude of the
destination
! LAT.  Touch to enter the latitude of the des-
tination
! E/W  Touch to switch between east longi-
tude and west longitude
! N/S  Touch to switch between north lati-
tude and south latitude
# To delete the entered number, touch Clear.
3 Touch Enter and then touch Yes.
Destination has been registered. is dis-
played briefly and new destination is set.
# To cancel setting the destination, touch No.