Controller Functions - Carrera RC Mini Turnator 360 Instructions De Montage Et D'utilisation

Controller functions

Differential Steering
7
You can use the joysticks to carry out precise
steering and driving manoeuvres.
Joystick left and right: Forwards and back-
wards with steady movement of left and right
joysticks at the same time.
Steer the car to the left by pushing the right-
hand joystick forwards and releasing it again.
Steer the car to the right by pushing the left-
hand joystick forwards and releasing it again.
Flip action stunts
8
The flip can be triggered by moving both joy-
sticks quickly and simultaneously in opposite
directions either upwards or downwards to
the stop, and the car turns a somersault.
360° turn
9
By moving both joysticks and steadily up and
down in opposite directions the vehicle can
be made to rotate 360 ° on the spot.
10 Thanks to 2.4 GHz technology, up to 16
cars can be run together on one race-track.
This is possible even without harmonising fre-
quencies between the racing drivers.
Troubleshooting
Problem: Car does not move.
Cause: Either the switch on the controller or
the car is set to OFF.
Solution: Switch on.
Cause: The rechargeable battery in the car
is too weak.
Solution: Please recharge battery.
Cause: The car has come to a stop at an ob-
stacle.
Solution: The voltage surge protector has
switched the car off. Turn the ON/OFF switch
on the car to OFF, then back to ON, and place
the car on a clear surface.
ENGLISH
Cause: The battery or rechargeable battery
in the transmitter or model is too weak.
Solution: Insert new battery or recharged
battery.
Cause: The remote control is possibly not
correctly frequency bound with the receiver
on the model.
Solution: Carry out a frequency bind be-
tween the model and the remote control as
described in "Now you can drive the car".
Cause: Within approx. 30 minutes of inactivi-
ty, the controller and vehicle switch off auto-
matically.
Solution: To restart, switch the ON/OFF
switch on both controller & vehicle to OFF
and then back to ON.
Cause: The vehicle is very warm.
Solution: Switch both car and controller off
and allow the car to cool down for about 30
minutes.
Cause: The overheat protection has caused
the car's motor to cut out due to excess tem-
perature.
Solution: Switch off the receiver. Leave
the RC car to cool down for approx. 30
minutes.
Problem: Car cannot be controlled.
Cause: Vehicle starts moving unintentionally.
Solution: Carry out a frequency bind be-
tween the model and the remote control as
described in "Now you can drive the car".
Errors and changes excepted
Colours / final design – changes excepted
Technical changes and design-related changes excepted
Pictograms = symbolic photos
16