Wiring Diagram - Napoleon GDS60-1N Instructions D'installation Et D'opération

44

8.0 WIRING DIAGRAM

EN
This appliance comes equipped with a battery back-up. If this backup is used, install 4 AA batteries (not
supplied) into the holder and connect to the wire harness. Place near the IPI board. Connect the battery
holder to the wire harness before using the appliance. Place near the IPI board. If backup is used, it must be
connected to the 6 volt battery pack (supplied).
TRANSFORMER
BATTERY
HOUSING
WITH "B" VENT ADAPTORS THE SPILL SWITCH MUST BE WIRED IN SERIES WITH EITHER THE
EXISTING SWITCH OR OPTIONAL WALL SWITCH, THERMOSTAT OR REMOTE.
W415-1328 / A / 01.05.16
DO NOT WIRE 110 VOLTS TO THE VALVE OR WALL SWITCH.
ACS/IPI
SWITCH
(OPTIONAL)
ON / OFF
SWITCH
ON / OFF
DISCONNECT THESE
CONNECTIONS TO THE
ON/OFF SWITCH. CONNECT
AN OPTIONAL THERMOSTAT
OR REMOTE CONTROL AND
IF ALLOWED WITH THIS
APPLIANCE A "B" VENT
ADAPTOR.
DC SUPPLY
WARNING
!
IPI / CPI
GROUND
EYELET
GROUND
GREEN
ORANGE
VALVE
ELECTRONIC
VALVE
IPI BOARD
69.5A
DFC