Assembly And Preparation - Evolution EVOMAG 28 Manuel D'utilisation

FIG. 1
EVOMAG75 shown above.
Others machine are very similar.
FIG. 2
EVOMAG75 shown above.
Others machine are very similar.
FIG. 3
EVOMAG75 shown above.
Others machine are very similar.

ASSEMBLY AND PREPARATION

WARNING: These machines must not be connected to a power
source until all assembly and preparation has been completed and
a safety check carried out. Evolution Mag Drills can only to be
used on non-coated Mild Steel. Ensure the surface is free of
paint and loose rust before attempting to drill.
Note: All these machines share many similar features and operating
systems. Read these instructions carefully. Where there are specific
requirements for a particular machine these will be acknowledged
in the text.
• Remove the machine from the carry case and check that all
accessories are present and correct.
WARNING: Enlist competent help when lifting this machine.
• Place the machine on a clean, sturdy work bench or similar.
• Attach the three (3) spindle feed handles to the spindle hub,
ensuring that they are fully screwed home. (Fig. 1)
• Attach the cutter safety guard and secure in place using the
supplied fixing screws. (Fig. 2)
• Attach the coolant tank to the left hand top of the machine using
the screw(s) provided.
• Loosen and remove the 'sleeve nut' at the base of the coolant tank.
• The coolant delivery tube should be pushed fully onto the
exposed union and secured with the 'sleeve nut'.
• The 'free' end of the delivery tube pushes into the brass 'quick
connector' which is screwed into the coolant inlet port. (Fig. 3)
Note: To release the delivery tube from the 'quick connector', push the
plastic collar towards the brass body and withdraw the delivery tube.
Note: For some operations it may be convenient to remove the
coolant tank and delivery tube and use an alternative method of
coolant application.
GEAR SELECTION
EVOMAG75
GEAR No Load
RPM
1
200/120
(60mm - 75mm)
2 260/150
(45mm - 60mm)
3
390/230
(35mm - 45mm)
4
490/290
• Always select the gear required before you start any cutting
20
www.evolutionpowertools.com
CUTTERS TAPS
2-3/8" - 3" 9/16" - 15/16"
(15mm - 24mm)
1-3/4" - 2-3/8" 9/16"
(15mm or less)
1-3/8" - 1-3/4"
N/A
1-3/8"
N/A
(35mm or less)