Step 4: Door Removal And Reinstallation - Thermador PROFESSIONAL PRO GRAND 60 Série Mode D'emploi

STEP 4: Door Removal and
Adjustment
CAUTION
• USE CAUTION WHEN REMOVING THE DOOR.
THE DOOR IS VERY HEAVY. Use both hands to
remove or replace the door. Failure to grasp the oven
door firmly and properly could result in personal injury
and product damage.
• Make sure oven is cool and power to the oven has
been turned off before removing the door. Failure to
do so could result in electrical shock or burns.
• With the door off, never release the levers and try to
close the hinges. Without the weight of the door, the
powerful springs will snap the hinges closed with
great force.
NOTE: The oven doors must be removed in order to
access the leveling screws for the rear castors (see
"STEP 9: Placing and Leveling the Range" on page 20). On
models with a warming drawer, the screw for the left castor
may be accessed by pulling the warming drawer open.
DO NOT remove the warming drawer or steam oven doors,
if applicable.
To Remove the Oven Door
1. Be sure to read the above
2. Open the door fully.
3. Flip hinge clip down. A
4. Close the door gently until it
Installation Instructions
CAUTION before attempting
to remove the door.
screwdriver may be required
to carefully pry the clip back.
stops against the hinge clips.
The open hinge clips will hold
the door open at a slight
angle, about 30°, from the
closed position.
5. Grasp the door firmly on the
6. Place the door in a safe and
To Reinstall the Oven Door
1. Hold the door firmly in both
2. Hold the door at a 30° angle
3. Open door fully to expose
4. Flip the hinge forward and
5. Close and open the door
To Check Door Fit and Adjustment
1. Open and close the door slowly to test the movement
and the fit of the door to the oven cavity. DO NOT force
the door to open or close. If the door is properly
installed, it should move smoothly and rest straight on
the front of the range when closed.
2. The range must be level for proper alignment of the
oven doors, see "STEP 9: Placing and Leveling the
Range".
3. If the door does not operate correctly, verify that the
hinges are properly seated into the hinge slots, and
that the hinge clips are fully engaged into the slots.
ends of the door. Lift the door
up and out. There will be
some spring resistance to
overcome.
stable location.
hands.
from the closed position.
Insert hinges centered evenly
into the hinge slots. The
hinges will securely hook into
the slots when properly
installed. DO NOT force,
bend or twist the door.
hinges, levers, and slots.
down until seated on the
bracket. A screwdriver may
be required to carefully push
the clip back.
slowly to ensure it is correctly
and securely in place.
English | 12 |