Intended Use - Oase ProfiLux Garden LED Controller Notice D'emploi

Intended use

ProfiLux Garden LED Controller, referred to as "unit", may only be used as specified in the following:
• As a controller for ProfiLux Garden LED RGB.
• For use in water fountain systems and ponds.
• For use above and under water.
• Operation under observance of the technical data.
The following restrictions apply to the ProfiLux Garden LED Controller:
• Operation in swimming pools, bath tubs or water courses which could be used by persons, is forbidden!
Permissible ambient temperatures for operation
• Underwater installation: Water temperature of +4 °C to +35 °C.
• Dry installation: Air temperature of -10 °C to +40 °C.
Installation
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
• Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
• Isolate the device (disconnect from the power supply) before carrying out any work on it.
 A
The device can be installed in or outside of the water.
Connection
Correctly connect the EGC units
The correct fastening of the plug connector is important for a secure connection and an interference-free EGC network.
How to proceed:
 B, C
1. Remove the protection cap from the unit.
2. Fit the plug connector and secure with the two screws (max. 2.0 Nm).
– Ensure that the rubber seal is clean and fits exactly.
– Replace the rubber seal if damaged.
3. Remove the protection cap from EGC-OUT of the last unit in the EGC network, fit the terminal resistor and secure it
with the two screws (max. 2.0 Nm).
– No EGC connection cable is connected to EGC-OUT on the last unit in the EGC network. The terminal resistor
has to be fitted to this EGC-OUT so that the EGC network is correctly terminated?.
– The terminal resistor is included in the delivery scope of the InScenio FM-Master WLAN EGC.
- EN -
11