JVC AV-24F704 Manuel D'instructions page 10

REMOTE CONTROL
DVD setup
The remote control is programmed with DVD codes for power on, power off, play, stop, fast-forward, rewind, previous
chapter, next chapter, tray open/close, and still/pause operation.
1) Find the DVD player brand from the list of codes shown below.
2) Slide the first 2-way selector switch to "TV" and the other 2-way selector switch to "DVD".
3) Press and hold down the DISPLAY button.
4) With the DISPLAY button held down, enter the first code number listed with the 10 key pad.
5) Release the DISPLAY button.
6) Confirm the operation of the DVD player.
• If your DVD player does not respond to the first code, try the others listed. If it does not respond to any code, try
the Search Codes Function as shown below.
• After you program your remote, some DVD buttons may not work properly. If some buttons do not work
properly, use the remote control which came with your DVD player.
DVD Player CODES
Aiwa 043
Apex 040
Denon 020, 037
Hitachi 030, 031
JVC 000
Kenwood 035
Konka 039
Mitsubishi 025
Onkyo 041
Oritron 044
Panasonic 020
Philips 023, 036
Pioneer 022
DVD Player Search Codes Function:
1) Slide the first 2-way selector switch to "TV" and the other 2-way selector switch to "DVD".
2) Press the DVD POWER and RETURN buttons. Hold for at least three seconds and release.
3) Press DVD POWER, see if the DVD player responds.
4) If there was a response, press RETURN. The operating codes are now set. If there was no response, repeat Step 3.
If you repeat Step 3 a total of 30 times without a response, use the manufacturers remote control which came with
the DVD player.
5) Press RETURN to exit.
10
DVD Player CODES
Raite 033
RCA 021, 026
Sampo 034
Samsung 030
Sharp 028
Silvania 038
Sony 024, 045, 046, 047
Technics 020
Toshiba 023
Wave 042
Yamaha 020
Zenith 027, 032
(CONTINUED)