Binks Airless 75 Mode D'emploi page 3

0811-7500-2
0811-7500-3
The following instructions provide the necessary information for other operation and preventative maintenance of the
BINKS Airless 75 7500 PSI Airless Spray Gun. It is the customer's responsibility to have all operators and service
personnel read and understand this manual. Please read and understand all information in this document in order to
safely operate your new spray gun.
EYE HAZARD: Failure to wear safety glasses with side
shields could result in serious injury or blindness. All
operators and bystanders must always wear safety glasses
with side shields that conform to ANSI Standard Z87.1 or
European Norm 156.
HAZARD: INJECTION INJURY – a high pressure stream
produced by this equipment can pierce the skin and
underlying tissues, leading to a serious injury and possible
amputation. See a physician immediately.
DO NOT TREAT AN INJECTION INJURY AS A SIMPLE CUT!
Injection can lead to amputation. See a physician immediately.
HAZARD: BURN HAZARD: When using the Airless 75 with a
fluid heater, equipment surfaces can become very hot.
ALWAYS use heat guard 54-7527 when spraying heated
materials. Do not exceed 175°F fluid temperature. Do not
exceed manufacturer recommended fluid temperature.
SAFETY PRECAUTIONS:
KEEP CLEAR OF NOZZLE: Do not exceed maximum working
pressure of 7500 PSI (517 BAR, 51.7 Mpa).
PREVENTION:
NEVER Aim the gun at any part of the body.
2
Airless 75
7500 PSI Airless Spray Gun
For trained, professional use only!
Maximum working pressure: 7500 PSI
– 517 BAR – 51.7 Mpa
Models 0811-7500-1, 0811-7500-2, 0811-7500-3
SAFETY, OPERATING AND
MAINTENANCE
INSTRUCTIONS INSIDE!!
Read all warnings and
operating information inside
SAVE THIS MANUAL FOR FUTURE
REFERENCE
Contact your local Binks
representative for Additional copies of
this manual
NEVER Allow any part of the body to touch the fluid stream. DO
NOT allow body to touch a leak in the fluid hose.
NEVER Put hand in front of the gun. Gloves will not provide
protection against an injection injury.
ALWAYS lock the gun trigger, shut the pump off, and release all
pressure before servicing, cleaning the tip or guard, changing the
tip, or leaving unattended. Pressure will not be released by
turning off the motor. The PRIME/SPRAY valve must be turned
to PRIME to relieve the pressure.
RELIEF PROCEDURE described in the pump manual.
ALWAYS Keep the tip guard in place while spraying. The tip
guard provides some protection, but is mainly a warning device.
ALWAYS Remove the spray tip before flushing or cleaning the
system.
The paint hose can develop leaks from wear, kinking, and abuse.
A leak can inject material into the skin. Inspect the hose before
each use.
NEVER Use a spray gun without a trigger lock and trigger guard
in place and in good working order.
All accessories must be rated at 7500 PSI (517 BAR) or higher.
This includes spray tips, guns, extensions, and hose.
NOTE TO PHYSICIAN:
Injection into the skin is a traumatic injury. It is important to treat
the injury as soon as possible. DO NOT DELAY treatment to
research toxicity. Toxicity is a concern with some coatings
injected directly into the blood stream.
plastic surgeon or reconstructive hand surgeon may be
advisable
0811-7500-1
Refer to the PRESSURE
Consultation with a
3