Mounting Instructions; Safety Instructions And Warnings - Maico ER-RPK Instructions De Montage

Mounting instructions

ER-RPK replacement kit
(article no. 0093.1563)
Scope of delivery
- 1x blind plug
- 1x retaining bolt
- 1x central retaining bolt for cover
- 1x exhaust adapter
- 1x housing floor seal
- 1x adapter board
- these instructions
Intended use
The ER-RPK replacement kit is used for
mounting the ER EC fan insert in ER-UP/G,
ER-UPD, and ER-UPB housing.
Safety instructions and
warnings
WARNING
Risk of injury when working at heights.
Use appropriate, certified climbing aids

Stability should be ensured, if
(ladders).
necessary have the ladders steadied by a
2nd person.
Ensure that you are standing securely

and cannot lose your balance and that there
is no one under the unit.
CAUTION
Intended operation not ensured if
installed incorrectly. A fan not installed
correctly may result in operation not as
intended.
Only install fan in accordance with the

planning documents.
In particular, note the models on

ventilation channels and sound deadening.
DANGER
Danger from operating with the fan not
fully mounted. Electric components are
a potential source of electric shock.
If the unit is open, all off the supply

circuits must be switched off (mains fuse
off), secured against being accidentally
switched back on and a visible warning sign
positioned.
 Only operate the fan when it is
completely installed.
 Do not cover the fan.
DANGER
Danger if the relevant regulations for
electrical installations are not
observed.
Before removing the upper housing

part/fan insert and before installing the
electrics, switch off all supply circuits as well
as the mains fuse and secure them against
being accidentally switched back on again.
Attach a warning sign in a clearly visible
place.
 Be sure to observe the relevant
regulations for electrical installation; e.g.
DIN EN 50110-1, in Germany this is
particularly VDE 0100, with the
corresponding parts.
 A mains isolation device with contact
openings of at least 3 mm at each pole is
mandatory.
 Only connect unit to permanently wired
electrical installation and with NYM-O or
NYM-J cables, depending on the unit
variant, 3x 1.5 mm² or 5x 1.5 mm².
The units may only be operated using the

voltage and frequency shown on the rating
plate.
5