Neriox 121856 Mode D'emploi page 4

4
121856
DIGITAL DIAL GAUGE
Operating instructions
Specification
Resolution: 0.01 mm / 0.001 mm
Measuring range: 12.7 mm / 25.4 mm / 50 mm
Operating temperature: 0 - 40°
Power: Lithium battery CR2032 / 3.0 V
Digital output: RS232
Features
Digital LCD display
Protection class IP 65
Zero position (ZERO)
Measuring mode ABS / INC
SET / CAL (input preset value)
SET / TOL (tolerance input)
MAX / MIN / MAX-MIN function
Change mm / inch
Change measuring direction
Safety information
• Use the dial gauge only at the permissible operating temperature
• Do not drop the dial gauge on the floo
• Protect the dial gauge against mechanical damage
• The dial gauge may only be disposed of in compliance with the regulations
Key:
1. Battery compartment
2. Display
3. Data output interface
4. ZERO(ON/OFF) button
5. SET button
6. MODE button
Comments:
In the following instructions, the meanings are as follows
Briefly press → press button for less than 2 seconds
Hold down → press button for more than 2 seconds
Important information before using the dial gauge
1. Dirt on the measuring spindle affects its movement. If necessary, clean the
measuring spindle with a cloth. Under no circumstances should oil be used
to lubricate the measuring spindle.
2. If necessary, clean the housing with a dry cloth. In case of heavy soiling,
use a neutral-reacting solvent. Do not use organic solvents (such as benzine
or thinner) under any circumstances - this will damage the device and cause
it to malfunction.
3. Protect the data input port with the appropriate cover when not in use.
4. The dial gauge must be clamped in a suitable holding device (e.g. dial gauge
stand) with locating hole 8H7.
5. Unauthorised opening of the digital meter will result in loss of the warranty.
1
6
2
3
4
5