When The Work Is Done - Bosch BSG8 Série Notice D'utilisation

12
Figure
You can use the parking aid on the
back of the vacuum cleaner if you
wish to stop vacuuming for a short
time.
Slide the plastic lug on the tool con-
nector into the groove at the back of
the vacuum cleaner.

When the work is done

Figure
13
Switch the vacuum cleaner off and
unplug the power cord from the
mains.
Tug the power cord and let go. The
cable then rewinds automatically.
To reactivate or deactivate the cable
brake, quickly tug the power cord.
Figure
14
To store or transport the vacuum
cleaner, use the storage aid on the
underside of the vacuum cleaner.
Stand the vacuum cleaner up on its
end. Slide the plastic lug on the floor
tool into the groove on the underside
of the unit.
Changing the dust bag and filters
Replacing the MEGAfilt
dust bag
Figure
15
If the dust bag change indicator lights
up brightly and evenly when the floor
tool is lifted from the carpet and the
highest suction power is selected, the
dust bag must be changed, even
though it may not yet be full. In this
case it is essential to change the dust
bag due to the type of material it con-
tains.
Open the dust bag compartment lid
by moving the dust compartment
locking lever in the direction of the
arrow.
Figure
16
Seal the MEGAfilt
by pulling the self-seal tap and then
remove it.
Figure
17
Insert a new MEGAfilt
bag into the holder and close the dust
bag compartment lid.
Caution: the dust bag compartment
!
lid will only close when the
MEGAfilt SuperTEX disposable or
®
textile filter are inserted.
If the dust bag change indicator is
still lit after the dust bag has been
changed, please check whether the
nozzle, tube or flexible hose are
blocked.
en
SuperTEX
®
SuperTEX dust bag
®
SuperTEX dust
®
7