Mitsubishi Electric PAC-IF021B-E Mode D'emploi page 18

. Remote controller operation
[Function selection flow chart]
Setting language(English)
Normal display
Hold down the ( ) button and press the ( ) button for 2 seconds.
Change
Language
Function
selection
Mode
selection
Display mode
setting
1
Hold down the ( ) button and press the ( ) button for 2 seconds.
English German Spanish
Swedish French
OFF
Present setting:Select mode=OFF
Select mode = OFF
OFF
Present setting:Limit TEMP. = OFF
Limit TEMP. = OFF
OFF
Dot display
Russian
Italian
No1
OFF ... Operation lock setting is not used.(Initial setting)
No1 ... Operation lock setting for all buttons except ON/OFF is active.
No2
No2 ... Operation lock setting for all button is active.
Present setting:Select mode=ON
Select mode = ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
Present setting:Limit TEMP. = ON
Limit TEMP. = ON
Lower limit
Upper limit
Lower limit
Upper limit
Lower limit
Upper limit
MAIN ···· The remote controller will be the main controller.(Initial setting)
SUB ···· The remote controller will be the sub controller.
ON ···· The clock function can be used.(Initial setting)
ON
OFF ···· The clock function can not be used.
OFF
*
TIMER MODE OFF : Timer mode can not be used.(Initial setting)
WEEKLY TIMER : Weekly timer can be used.
*
AUTO OFF TIMER : Auto off timer can be used.
SIMPLE TIMER : Simple timer can be used.
* These are timer mode.
*
OFF ···· The set contact numbers are not displayed in case of error.
OFF
(Initial setting)
ON
ON ···· The set contact numbers are displayed in case of error.
ON ···· The offset function of the water temperature can be used.
ON
(Initial setting)
OFF
OFF ···· The offset function of the water temperature can not be used.
°C
°C ···· The temperature unit "°C" is used.(Initial setting)
°F ···· The temperature unit " °F" is used.
°F
OFF OFF ···· Water temperature is displayed.(Initial setting)
ON ···· Water temperature is not displayed.
ON
TEMP. ON/OFF
Select mode = OFF (Initial setting)
• All operation modes are available in
this mode.
Select mode = ON
• Selected mode is skipped.
OFF ···· Skipped
ON ···· Available
Limit TEMP. = OFF (Initial setting)
• Water temp. setting range : standard
Limit TEMP. = ON
• Water temp. setting range : limited
Lower limit ···· sets the lowest water
temperature.
Upper limit ···· sets the highest water
temperature.
( )
* "LIMIT TEMP. HOT WATER" mode
also limits the setting range in the
"Heating" mode.