Graco SNUGRIDE I-SIZE Mode D'emploi page 14

EN
Rotate Support Leg Out
1
Place base on vehicle seat. The support leg has
2
two buttons to allow the length to be adjusted.
Press the buttons to adjust the leg length. The
sure the load leg is secure by pressing down on
the base.
3
Extend the ISOFIX connectors.
Squeeze the ISOFIX extender buttons and pull
the ISOFIX connectors out.
4
Press the ISOFIX connectors onto the vehicle
anchors until a click is heard. When the ISOFIX
connectors are locked the connection indicators
will be green. If the base is not locked in the
indicators will be red.
5 Squeeze the ISOFIX extender buttons. Push down
rmly on the base towards the back of the
vehicle seat to ensure a tight t on the seat.
6
To release the base from the vehicle seat pull the
ISOFIX release lever and remove base.
7
Recline Car Seat
To recline the car seat pull recline handle and
slide into correct position for your child.
Attaching the car seat to the base
8
To attach seat to base, position front of seat in
base then push down on the back until it locks
into place. (See Illustration).Pull up on car seat
to be sure it is securely xed onto base.
14
To remove, squeeze release handle at back of the
9
car seat to release the attachment catch. Lift car
seat from base as shown. Always place handle
in the down position when removing your baby
from the seat and if you place the car seat onto
oor. Make
Car Seat Installation
without Base
10
Place Car Seat Rear-Facing in the Vehicle
Place the car seat on the vehicle seat. Push it
back until the front of the car seat touches the
vehicle seat back.
11
Put lap section of belt over car seat and under
the two belt hooks marked with blue labels.
Buckle the vehicle belt.
12
Place shoulder belt around the back of the car
seat exactly as shown, making sure to run it
through the center guides on the back of the seat
and below the notch opposite the shoulder belt
and not be twisted. Make sure buckle and seat
belt are in line with each other. Contact Graco if
in doubt about this point.
13
Tighten Vehicle Seat Belt
Lay your forearm across the car seat at the belt
path and push down. Pull on the shoulder
belt to tighten while feeding the slack back into
the retractor.