Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
10
K44 Duo Installation & User manual
Programming
Before you start programming K44 Duo, make a
note of the codes to be used, to what timing group
they should belong and which relay output they
should control. At the back of this manual you
will find a chart designed for this purpose. Look
at the chart as you program K44 according to the
instructions below.
Buzzer and LEDs
During programming you will be guided by the
buzzer and the LEDs.
In programming mode before a function is
chosen: Green and yellow LED flashes.
During programming: Yellow LED goes out.
Green LED is lit.
Correct instruction: Confirmed by a rising signal
consisting of two quick beeps.
Faulty instruction: Confirmed by a falling signal
consisting of two quick beeps.
NOTE! During programming mode, if a button is
not pressed within 20 seconds, the code
lock goes back to normal operation.
K44 Duo Installation & User manual
Choose password
The first thing to do before you can start program-
ming is to choose a password.
1
Press and hold the SW1 button on the code
lock's circuit board. Both LEDs are lit.
2
Enter a 6-digit password.
3
Make a note of the new password in the chart
at the back of the manual.
Change password
1
Press B and enter the current password.
2
Enter A27.
3
Enter the new password. A warning tone is
heard.
4
Enter the new password once again.
5
Press B to leave programming mode.
6
Make a note of the new password in the chart
at the back of the manual.
Programming commands
Always press B and the password before any
commands are used.
Leaving the programming mode can be done by
pressing B.
11
Publicité
Chapitres
Table des Matières
