Door Monitoring On/Off; Set Door Held Warning Time - Siemens K44 Duo Manuel D'installation Et Utilisation

18 K44 Duo Installation & User manual
This is how to choose one of the functions:
1 Press B and enter the current password.
2 Enter A69.
3 Enter either:
0 = Door Alert (default).
1 = Duress

Door monitoring on/off

If door contacts are used and this function is acti-
vated, a warning signal sounds during the time set
as door held warning time, i.e. when the opening
time has expired and the door is still open.
If the door held warning time expires and the door
is still open, the alert output is activated (if the
Alert function is activated). This also happens if
the door is forced open.
This is how to activate Door monitoring:
1 Press B and enter the current password
2 Enter A67.
3 Enter 1.
To deactivate Door monitoring, press 0 in step 3
instead.
K44 Duo Installation & User manual

Set door held warning time

If the door is still open when the opening time has
expired, a buzzer sounds as to remind the visitor
to close the door immediately – or the alarm out-
put will be activated. The buzzer sounds until the
door is closed.
Note that door contacts must be connected and
that Door control must be activated for this to
work.
This is how to change the door held warning time,
if needed:
1 Press B and enter the current password.
2 Enter A29.
3 Enter the desired door held warning time (01-
99) with two digits, e.g. 09 for 9 seconds.
4 Choose to which relay outputs the new door
held warning time should apply:
0 = both
1 = relay output 1
2 = relay output 2
19