Installation (Common To Both Models) - JUKI DLN-6390 Manuel D'utilisation

@. INSTALLATION (COMMON TO BOTH MODELS)

WARNING :
• Perform the installation of the sewing machine by the technical personnel who have been trained.
• To prevent personal injury, ask our dealer or the electrician for electric wiring.
• Be sure to perform the work with two persons or more when transporting the sewing machine and use a
lorry when moving it.
• To prevent personal injury caused by abrupt start of the sewing machine, do not connect the power plug
until the set-up of the sewing machine is completed.
• Be sure to earth the ground wire to prevent personal injury caused by leak.
• Be sure to attach safety protection cover, fi ger guard, etc.
< Table >
Arrange the relation of position between the table, motor, pneumatic components, etc. referring to the drawing of table below.
A
4× φ 3.5 depth 10
(Installing position of
rubber cushion)
A : Rubber cushion installing position (4 places)
B : Position of wood screw for fi xing bobbin winder base (3 places)
C : Position of wood screw for fi xing air unit (2 places)
D : Position of wood screw for fi xing knee lifter unit (bottom surface) (4 places)
E : Position of wood screw for fi xing table/stand (4 places)
Drawing of table for reference
351
24
300
240.5
49
φ 40±0.5 drilled hole
159
Z Z
303
20
183
213
278
D
4× φ 3.5 on the
b o t t o m s u r f a c e
depth 20
75
298
393.3
414
φ 70 drilled hole
830
116
φ 18 drilled hole
580
57
B
3× φ 3.5 depth 10
28
48.3
Z-Z (3 places) Position of motor fi xing bolt
φ 35 drilled hole
– 2 –
50 40
110
325
C
2× φ 3.5 on the
bottom surface depth 10
E
4× φ 3.5 on the
bottom surface depth 20
(For fi xing table/stand)
φ 26
φ 8.5