Din Rear-Mont; Installation Using The Screw Holes On The Side Of The Unit - Pioneer DVH-P5000MP Manuel D'installation

Installation
DIN Rear-mount

Installation using the screw holes on the side of the unit

1. Remove the frame.
2. Fastening the unit to the factory radio mounting bracket.
14
En
Frame
Factory radio
mounting bracket
Insert the release pin into the hole in the
bottom of the frame and pull out to remove
the frame. (When reattaching the frame,
point the side with a groove downwards and
attach it.)
Select a position where the screw holes of the
bracket and the screw holes of the head unit
become aligned (are fitted), and tighten the
screws at 2 places on each side. Use either
truss screws (5 × 8 mm) or flush surface screws
(5 × 9 mm), depending on the shape of the
screw holes in the bracket.
Screw
Dashboard or Console