Electrical Connection; Installation And Connections - Hama 00095222 Mode D'emploi

Electrical connection

GB

Installation and connections

46
The electrical connections must be made according to the following
instructions in order to ensure safe and error-free operation:
■ Before you connect the device, compare the connection data for
the power supply adapter (voltage and frequency) on the type
plate with that of your mains power supply. This data must match
to avoid damage to the device.
■ Keep the cable away from hot surfaces and sharp edges.
■ Make sure not to bend the cable or pull it too tightly.
For continuous playback, the device can be placed on a flat surface or
hung on the wall.
If you want to put the device on a flat surface, attach the supplied base
to the rear of the device.
 Screw the base into the base opening
 Position the device upright or on its side. To do so, turn the base
to the appropriate position.
CAUTION
The device can be damaged if it tips over or falls down.
► Make sure that the device cannot tip over.
 Connect the connection cable to the socket
plug in the power supply adapter.
NOTE
► Only use the enclosed power supply adapter.
14
on the device.
12
on the device and
DPF DVB-T