Scanning; Clock - TechniSat DIGITRADIO 51 Mode D'emploi

7 Scanning

Once a scan is complete the radio returns to playing the previously selected station or first station on the
station list. You may need to repeat this occasionally for the following reasons:
- New stations may become available from time to time.
- Stations closed or can no longer be received.
- If reception was not good for the original scan (for example the antenna was not up), this may result in
an empty or incomplete list of available stations.
- If you have poor reception of some stations causing the audio to break up, you may wish to list only
stations with good signal strength.

8 Clock

When you power up the unit (or after factory reset), the clock will set to "00:00".
In general, the radio automatically synchronises the clock from the DAB station after scanning.
To set the clock manually, please refer to 16.1.5.1.
9 Alarm setting
Your radio includes dual alarms. You can set alarm in the DAB mode or FM mode. Set alarm, making sure set
clock at first.
To set Alarm1, press and hold 'Alarm 1' button. To set Alarm 2, press and hold 'Alarm 2' button. The alarm icon '
' or ' ' will flash.
Press ' < ' or ' > ' button to set alarm state 'On', and then press 'Select/Menu' button to confirm.
Press ' < ' or ' > ' button to set hour part of alarm time, and then press 'Select/Menu' button to confirm.
Press ' < ' or ' > ' button to set minute part of alarm time, and then press 'Select/Menu' button to confirm.
Press ' < ' or ' > ' button to set alarm duration time, and then press 'Select/Menu' button to confirm.
Duration options: 15/30/45/60/90Mins
EN
FR
IT
NL
NW
DK
PL
CZ
SK
11