Yakima Kickstand 1X Mode D'emploi page 2

Slide the kickstand into place.
With the tongue separated from the trailer
slide the Kickstand onto the tongue.
Tighten down the kickstand.
Locate the two upper most
screws on the kickstand.
Stowing the kickstand.
Press the
silver buttons
to release the
kickstand.
1033561C-2/4
Using a crosshead head screwdriver
tighten down the screws. Use a wrench
to keep the nuts on the other side from
turning while you tighten the screws.
Fold the kickstand up.
Whether it is in the up or down position
be sure it locks into position.
Note: for instruction detailing how to
remove the tongue from the trailer
refer to your RACKandROLL manual.
Do not drive your vehicle with
kickstand in down position.