Running Data Setting - Hydro-Pro+ 5 Mode D'emploi

7. Running data setting

7.1 How to check the parameters
On standby or running mode, long press
parameters (from 0 to H, see operation parameter table).
7.2 How to adjust the parameters (Can only adjust on standby mode)
1) Long press
parameter table) you want to adjust.
2) Then press or
3) Then press or
for 10 seconds, press
to adjust the parameter, press
select the other datas you want to adjust, repeat above operation.
for 10 seconds, then press
again to select the data (from 0 to L, see operation
again to store the new data.
- 17 -
or to check the