König Electronic KN-MICW440 Mode D'emploi page 3

1. Antenna:
2. Power indicator:
3. AF indicator:
4. Diversity A - B indicator: The LED indicates the antenna is receiving a RF signal.
5. Balanced output:
6. Unbalanced output:
7. Mic/Line Switch:
8. Channel Selector:
9. Squelch Adjustment:
10. DC IN:
Fixed-length UHF antenna, permanently mounted.
The LEDs indicate when the receiver is ready to operate.
The LED indicates an audio signal is being received.
3-pin XLR connector provides balanced low-impedance
output.
Unbalanced 6.3mm mono jack audio output for connecting,
for example a guitar amplifier.
Select the output signal of the XLR balanced connector or
6.35mm unbalanced jack. It can be set for microphones
(-20dB) or line-level (0dB).
16 different selectable frequencies as below.
Note:
Prior to setting up, please check that the
transmitter and receiver are tuned to the
same frequency. Two or more transmitters
operating on the same frequency can not
be used at the same time in the same area.
So for each extra transmitter, please select
a different frequency which can be used
simultaneously.
The squelch adjusts the output level to prevent external
noise. Setting the squelch too high will reduce the range of
the system. Set the squelch to minimum before turning the
receiver on.
DC input connector for the supplied AC/DC adapter.
3