Features; Assembly; Operation - Ryobi PCL630 Manuel D'utilisation

PRODUCT SPECIFICATIONS
Light Output (High) ....................................... 1,800 Lumens
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not direct the light beam at persons or animals and
do not stare into the light beam yourself (not even from a
distance). Staring into the light beam may result in serious
injury or vision loss.
WARNING:
Do not allow familiarity with battery products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
NOTICE:
This product is designed to be powered by either a
Ryobi One+ 18V battery pack (DC mode) or by 120V
™
™
wall outlet (AC mode). Either power source can be used
by installing an approved battery pack or power cord into
the product as described in this manual.

FEATURES

Kelvin Rating .................................................Up to 5,000 K

ASSEMBLY

WARNING:
Do not attempt to modify this product or create accesso-
ries or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.

OPERATION

APPLICATIONS
You may use this product for the purpose listed below:
 General illumination of most work area spaces
WARNING:
Hybrid products are always in operating condition.
Therefore, the product should always be in the OFF
position, with the battery pack removed and power cord
disconnected, when not in use. Do not leave light on while
unattended. Failure to follow these instructions could
result in serious personal injury.
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 8.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, refer to the Operator's
Manuals for your battery pack and charger models.
WARNING:
Always remove battery pack or disconnect power cord
from the product when you are assembling parts, making
adjustments, cleaning, or when not in use. Removing
battery pack or disconnecting power cord will prevent
accidental starting that could cause serious personal
injury.
5 – English