Features; Operation - Ryobi P784 Manuel D'utilisation

PRODUCT SPECIFICATIONS
LED ......................................................... 6 Watts Maximum
Maximum Light Output .............400 Lumens in High mode
WARNING:
Do not direct the light beam at persons or animals and
do not stare into the light beam yourself (not even from a
distance). Staring into the light beam may result in serious
injury or vision loss.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this tool for the purpose listed below:
 General illumination of most work area spaces
INSTALLING/REMOVING BATTERY PACK
See Figures 1 - 3, pages 6 - 7.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
 Depress the latches to remove the battery pack.
NOTE: It is not necessary to remove the battery pack from
the tool to recharge.
 With the battery installed, place the tool in an
EVERCHARGE wall mount adaptor by aligning the raised
™
ribs on the tool's EVERCHARGE
in the adaptor as shown.
 Slide the tool down until it is fully seated on the adaptor.
NOTE: If the light is on, once it is seated on the adaptor,
the light will turn off. If the light is off, once it is seated on
the adaptor, the light will flash and then turn off. Both the
light and the USB charging port will be inoperable until
the tool is removed from the adaptor.

FEATURES

OPERATION

port with the grooves
™
4 – English
Maximum Runtime .......................... 48 hours in Low mode
(Runtime is dependent on the type of battery pack)
USB Charging port ..................................................1 A, 5 V
 Observe the LED indicator beneath the power button to
determine the charge status.
NOTE: The LED indicator will flash quickly as the adaptor
evaluates the battery pack, it will flash intermittently while
charging and it will fade in and out when the battery is
fully charged.
NOTE: If the light "evaluates" a battery pack for longer
than 30 minutes at room temperature, the battery pack
or the light may be defective. Remove and reinstall the
battery pack. If the LED status repeats a second time, try
charging a different battery pack. If a different battery pack
charges normally, the first battery pack may be defective.
If the light "evaluates" the second battery pack for longer
than 30 minutes, the light may be defective.
 If the EVERCHARGE wall mount adaptor is disconnected
™
from an AC power source or a power outage occurs while
the light is attached, charging will stop and the light will
automatically turn on for up to 10 minutes. If the adaptor is
reconnected to an AC power source or power is restored,
the light will turn off and charging will resume.
TURNING THE AREA LIGHT ON/OFF
See Figure 4, page 7.
Press the power button to cycle between High, Medium,
Low, and Off.
NOTE: To start a flash sequence, press and hold the power
button for three seconds.
HANGING THE LED AREA LIGHT
See Figure 5, page 7.
WARNING:
Only hang or mount LED area light in an area where no
electrical wires, utility cables, pipes, or other obstructions
are located. Contact your local utility company or a
qualified electrician if you are unsure. Do not hang area
light from any electrical power cord. Ensure area light is
securely installed to prevent falling object hazard. Failure
to follow these instructions can result in electrocution,
electrical shock, or other serious personal injury.
 Lift the handle to the desired position for hanging.