Transmitter Radio Transmit Power - Jay Electronique ISIS Notice Technique D'installation Et D'utilisation

4.4- Transmitter radio transmit power

The transmitter ISE can operate with two different radio transmit
powers : 1mW or 10mW (selected by cursor No. 7 of transmitter
«CONFIG» DIP switch).
The choice of radio transmit power will depend on the application
in which the ISIS product is used.
The transceiver IST only works with 10 mW transmission power.
Important: a transceiver confi gured with 1mW transmit power
will not work.
1 mW radio transmit power :
(cursor No. 7 set to OFF)
If the range between the ISIS transmitter and receiver is
short or if the response time of an output must be fast (less
than 60ms max), it is preferable to select a transmit power of
1 mW.
Reminder: a transceiver IST confi gured with 1mW transmit
power will not work.
10 mW radio transmit power :
(cursor No. 7 set to ON)
If the range of the ISIS transmitter-receiver or between
transceivers IST is long, it is preferable to choose a radio
transmit power of 10 mW.
Warning: the response time of an output with 10 mW mode is
less than 500 ms max.
General remark :
If several radio systems are working in the vicinity of each other,
refer to the « Product installation safety requirements » section to
install your system.
FR
- 66 -
EN DE
CONFIG
ON
"1"
"0"
1 2 3 4 5 6 7 8
= cursor position
CONFIG
ON
"1"
"0"
1 2 3 4 5 6 7 8
= cursor position
ISIS - 331260D
revision02