Dab Reception; Remote Control - Yamaha TSX-140 Mode D'emploi

TROUBLESHOOTING

DAB reception

Problem
Cannot tune into any DAB
stations.
The initial scan operations
are not successful and "Not
found" appears on the DAB
information display.
The DAB station reception is
weak.
There is noise interference
(e.g. hiss, crackle or jitter).
The DAB station information
does not appear or is
inaccurate.

Remote control

Problem
The remote control does not
work properly.
18
En
Cause
The initial scan operations were not
performed.
There is no DAB coverage in your area.
The DAB signals are too weak.
The DAB signals are too weak.
There is no DAB coverage in your area.
The DAB signals are too weak.
The antenna needs to be repositioned.
The DAB signals are too weak.
The DAB station may be temporarily out
of service, or the DAB station
information is not provided by the DAB
broadcaster.
Cause
The remote control may be operated
outside its operation range.
The remote control sensor on the unit
may be exposed to direct sunlight or
lighting (inverted fluorescent lamps).
The battery may be worn out.
There are obstacles between the sensor of
the unit and the remote control.
Solution
Perform the initial scan operations
(☞ P. 8).
Check with your dealer or WorldDMB
Online at "http://www.worlddab.org" for a
listing of the DAB coverage in your area.
Change the height, direction, or placement
of the antenna.
Check with your dealer or WorldDMB
Online at "http://www.worlddab.org" for a
listing of the DAB coverage in your area.
Change the height, direction, or placement
of the antenna.
Contact the DAB broadcaster.
Solution
For information on the remote control
operation range, refer to "Using the remote
control" (☞ P. 1).
Change the lighting or orientation of the
unit.
Replace the battery with a new one.
Remove the obstacles.