Microwave Oven; Grounding Instructions - Everglades EV 270 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GB

MiCrowAVe oVeN

PreCAUTioNS To AVoiD PoSSiBle eXPoSUre To eXCeSSiVe MiCrowAVe
eNerGY
1. Do not attempt to operate this oven with the door open since open door operation can result in harmful
exposure to microwave energy. It is important not to destroydefeat or tamper with the safety interlocks.
2. Do not place any object between the oven front face and the door or allow soil or cleaner residue to
accumulate on sealing surfaces.
3. Do not operate the oven if it is damaged. It is particularly important that the oven door close properly
and that there is no damage to the
a. Door (bent),
b. Hinges and latches (broken or loosened),
c. Door seals and sealing surfaces.
4. The oven should not be adjusted or repaired by anyone except properly qualified service personnel.
BeFore YoU CAll For SerViCe
If the oven fails to operate:
1. Check to ensure that the oven is plugged in securely. If it is not, remove the plug from the outlet, wait
10 seconds, and plug it in again securely.
2. Check for a blown circuit fuse or a tripped main circuit breaker. If these seem to be operating properly,
test the outlet with another appliance.
3. Check to ensure that the control panel is programmed correctly and the timer is set.
Check to ensure that the door is securely closed engaging the door safety lock system. Otherwise, the
microwave energy will not flow into the oven.
iF NoNe oF THe ABoVe reCTiFieS THe SiTUATioN, THeN CoNTACT A QUAliFieD TeCHNiCiAN.
Do NoT TrY To ADJUST or rePAir THe oVeN YoUrSelF.
iNSTAllATioN
1. Make sure that all the packing materials are removed from the inside of the door.
2. wArNiNG: Check the oven for any damage, such as misaligned or bent door, damaged door seals
and sealing surface, broken or loose door hinges and latches and dents inside the cavity or on the
door. If there is any damage, do not operate the oven and contact qualified service personnel.
3. This microwave oven must be placed on a flat, stable surface to hold its weight and the heaviest food
likely to be cooked in the oven.
4. Do not place the oven where heat, moisture, or high humidity are generated, or near combustible
materials.
5. For correct operation, the oven must have sufficient airflow. Allow 20cm of space above the oven, 10cm
at back and 5cm at both sides. Do not cover or block any openings on the appliance. Do not remove
feet.
6. Do not operate the oven without glass tray, roller support, and shaft in their proper positions.
7. Make sure that the power supply cord is undamaged and does not run under the oven or over any hot
or sharp surface.
8. The socket must be readily accessible so that it can be easily unplugged in an emergency.
. Do not use the oven outdoors.

GroUNDiNG iNSTrUCTioNS

This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a
grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded. In the
event of an electrical short circuit, grounding reduces risk of electric shock by providing an escape wire for
the electric current. It is recommended that a separate circuit serving only the oven be provided. Using a
high voltage is dangerous and may result in a fire or other accident causing oven damage.


Publicité

Table des Matières
loading

Table des Matières