Gree GWH09QB-K6DNA1C/I Manuel D'utilisateur page 16

Introduction for buttons on remote controller
● When selecting "
louver will automatically swing up & down at maximum angle.
● When selecting " 、
● When selecting "
● Hold " " button above 2s to set your required swing angle. When reaching your
required angle, release the button.
Note:
" 、 、 " may not be available. When air conditioner receives this signal, the
air conditioner will blow fan automatically.
5
TURBO button
Under COOL or HEAT mode, press this button to turn to quick COOL or quick
HEAT mode. " " icon is displayed on remote controller. Press this button again
to exit turbo function and "
6
▲/ button
● Press "▲" or "
Holding "▲" or "
change quickly. On releasing button after setting is finished, temperature indica-
tor on indoor unit will change accordingly. (Temperature can't be adjusted under
auto mode)
● When setting TIMER ON, TIMER OFF or CLOCK, press "▲" or "
adjust time. (Refer to CLOCK, TIMER ON, TIMER OFF buttons) When setting
TIMER ON, TIMER OFF or CLOCK, press "▲" or "
to CLOCK, TIMER ON, TIMER OFF buttons)
7
SLEEP button
Under COOL or HEAT mode, press this button to start up sleep function.
" " icon is displayed on remote controller. Press this button again to cancel sleep
function and " " icon will disappear.
8
TEMP button
By pressing this button, you can see indoor set temperature, indoor ambient temp-
erature or outdoor ambient temperature on indoor unit's display. The setting on
remote controlleris selected circularly as below:
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
", air conditioner is blowing fan automatically. Horizontal
、 、 、
、 、
" icon will disappear.
" button once increase or decrease set temperature 1℃ .
" button, 2s later, set temperature on remote controller will
no display
" button to adjust time. (Refer
12
" button to