Installation Diagrams - golmar Rock Série Manuel D'installation

INSTALLATION DIAGRAMS

T-901
S-45 T-901VD
S+ S-
The total amount of call repeaters and telephones
placed in the same apartment is two.
For each item placed in parallel the section
corresponding to the I, 2 and S+ wires
must be doubled.
FA-805
PRI SEC
-
0 110 220 ~2 ~1 + C2 C1 ~2 ~1
Main
Dotted lines show the additionnal connections for autoswitch-on function activation.
L
ock release activation using an external push button.
The lock release can be activated at any moment
by using an external push button,
that must be connected between
This function will allows to exit from the building
being not necessary the use of a key.
O
ne access door.
Platea 5
-
1 2 CA U AM Mp Vp I A1 A2 B1 B2
CN1
- - A1
+ I AM Vp Mp
C2 C1 ~2 ~1
'C2' and ' ~1 ' terminals.
33 34
S
ections chart.
Door panel / Monitor
I
–, AM
Vp, Mp, A1
* For longer distances than 100m., Vp and Mp video wires must be twisted.
A
uxiliary devices activation.
Platea 5 monitors have two potential free contact push buttons (
auxiliary devices. If autoswitch-on function has been installed, it will be only possible
to use push button (terminals B1 and B2) to activate one auxiliary device.
The maximum load to be applied to one of these push buttons is 200mA/50Vd.c. However,
it's recommended the use of R-3 unit relays and one TF-104 transformer.
Usual applications are the activation of stairs light, second lock release, ...
INSTALLATION DIAGRAMS
Distance
Power supply / Panel / Lock release 50m.
–, + 1,50mm²
~1, ~2, C1, C2 1,00mm²
Distance
50m. 100m.
0,25mm² 0,50mm²
1,00mm² 1,50mm²
0,25mm² 0,25mm²
TF-104
R-3
SEC
~ ~ -
O B R T M U AM Mp Vp
100m.
2,50mm²
1,50mm²
200m.
1,00mm²
2,50mm²
0,25mm²*
and ) to activate
Platea 5
I A1 A2 B1 B2