How To Locate A Service Using The Conductive Rod - Leica Digisystem i780231 Manuel De L'utilisateur

4.3
Using the Conductive
Rod in Line mode
Digisystem, How to Use the Conductive Rod

How to Locate a Service Using the Conductive Rod

7
5 5 5 5
5 5 5 4
6
2
3
5
1
1. Insert the rod into the pipe, duct,
conduit or drain until the desired
length is in place.
2. Plug the Transmitter's cable set
into the connection socket
3. Connect the black cable to the
Earth Pin, ensuring that no
services are below push the Earth
Pin into the ground
4. Connect the red cable to the
positive (+) terminal on the
conductive rod.
5. Switch the Transmitter on,
observe the Connection mode
LED is illuminated and the battery
level is adequate. Change
batteries when indicated.
6. Select the required power
output level and frequency
output. A good level of tracing
signal is indicated when the
power output LED & audible
tone changes from pulsed to
continuous
7. Trace the length of the rod using
the Locator set to the same
frequency.
41