Important Notices - FAR ELEK 112508 Guide D'utilisation

WATER RECUPERATION
WATER DRAINING
When the unit is in cooling or dehumidification mode, the recuperated water will flow
into the tank. When the tank is completely full, a warning light will flash, a vibrating
alarm will sound eight times, and at the same time the «error» code «E4» will appear
in the liquid crystal display window. The compressor will stop working, whereas the
fan will remain active.
After three minutes, the unit will stop.
To empty the tank, follow the indications in the three drawings below. Remove the
water tank, empty the water from the tank, then replace it in its original position.

IMPORTANT NOTICES

1. When the unit is in cooling or dehumidification mode, if you remove the water
tank from its housing, the vibrating alarm will sound, the compressor will stop, and
the unit will pass into ventilation mode.
2. If you want to empty the tank before it is completely full : please stop the unit
first of all, and wait 3 minutes to prevent water running inside the unit, and after this
empty the tank.
3. Where the tank is placed, inside, there is a plastic pipe. Do not lift the tappet
while the unit is operating because the water is used to cool the copper tube.
112508-509-B.indd 34
© FAR GROUP EUROPE 2004
GB
21/03/05 10:40:58