FAR ELEK 112508 Guide D'utilisation page 32

SELECTION OF FUNCTIONS
1. Start the air conditioner:
Press the button «1/0», and this will start the apparatus.
2. Button "MODE" : This button allows choice of functioning mode of the apparatus.
There are five modes to choose from: ventilation, cooling function, dehumidification
function, heating (not for this model) or the automatic mode function.
3. Button for adjusting the airflow rate or fan speed button: there are three flow rate
speeds for the VENTILATION and COOL AIR modes. When you have selected the
function mode of the unit, press on this button to obtain HIGH, MEDIUM, or LOW.
4. Button for adjusting the temperature: As soon as the air conditioner is working,
in cooling COOL AIR mode, the display on the control panel will show the general
temperature (usually this will be different from the real ambient temperature). For
good practice, it is preferable to adjust the required temperature before choosing the
function mode.
Use the arrows
red temperature.
5. Time-set button, for programming the operating time of the air conditioner:
Use this button to programme the air conditioner: When the unit is working, indicate
the time to stop. The programming can be set over 24 hours.
Use the arrows
6. Stand-by button : When the unit is working, press this button to go into sleep
mode and press again to come out. This mode is not applicable in automatic mode.
* When the «programmer» is active, the air conditioner is in operating function. It
will begin operating according to the previous mode registered.
* Press on «TIMER» and choose «TIME» on the control screen, adjust the hours
and minutes of the programmer for the operating length of time with the buttons
Hr/Min..
* By pressing the «SLEEP» function you will cancel the «timer, programming»
function. By pressing the «TIMER programming» you will cancel the «sleep» func-
tion..
112508-509-B.indd 32
& to increase or reduce the programming of the requi-
& to increase or reduce.
© FAR GROUP EUROPE 2004
GB
21/03/05 10:40:58