Part List; General Installation - NORAUTO 2271068 Mode D'emploi

disconnected, keep the lid closed.
EN
30 Pay attention when manoeuvring or lifting the
cooler as it may be heavy when fully loaded. Only
lift if it is within your own physical capabilities.
31 The plug will become warm during use. Ensure
that the vehicle socket is clean and clear of debris,
and the electrical contact is good to avoid the
plug/socket overheating.
32 Take care when removing the plug from the
12/24V DC socket and DO NOT touch the metal
contacts which may be hot.
33 Danger of electric shock! Do not attempt to repair
the appliance yourself. Improper repairs can lead
to considerable hazards. In case of malfunction,
repairs are to be conducted by qualified personnel
only.
34 The supply voltage shall be the same as that
indicated in the technical specifications and the
appliance rating plate.

PART LIST

1 Side handle
2 Lid
3 Lid latch
4 Ventilation slots
5 Connection cable for AC
6 Connection cable for DC
7 ON/OFF button
8 SET button
9 UP button
10 DOWN button
11 Divider
INSTALLATION

GENERAL INSTALLATION

The following points should be considered when choosing a location to install the unit:
• A minimum clearance of 50 mm must be maintained on all sides of the compressor
cooler.
• The compressor cooler shall be attached to secure anchorage points.
• The ideal mounting position for the compressor cooler is on a flat, horizontal surface.
If the compressor cooler is subject to sideways angles (for example: heal on a boat), it
can withstand sideways angels of 30 degrees.
52
1
2
3
4
2
3
5
6
7
8
9
10
11