Grille Installation; Door Swing - Viking 5 Série Manuel D'installation, D'utilisation Et D'entretien

Installation

Grille Installation

REMOVING AND INSTALLING GRILLE
!
WARNING
Disconnect electric power to the unit before removing the
grille.
When using the unit, the grille must be installed.
!
WARNING
DO NOT touch the condenser fi ns. The condenser fi ns are
SHARP and can be easily damaged.
Removing the grille
1. Disconnect power to the unit.
2. Loosen the two screws (1).
3. Remove grille (2) from unit.
Installing the grille
1. Align cabinet and grille holes and secure, but do not
over tighten grille screws (1).
2. Reconnect power to the unit.
2
1

Door Swing

2-1/8" Min.
(54 mm)
90°
Door Swing
Stainless Steel, Black and White
Units have a zero clearance for the door to open 90
installed adjacent to cabinets.
Stainless steel models require 2-1/8" (54 mm) door clearance
to accommodate the handle if installed next to a wall.
8
Wall
o
, when