Leveling And Door Alignment; Leveling; Door Alignment - LG LFX29945ST Manuel Du Propriétaire

Leveling and Door Alignment

Leveling

After installing, plug the refrigerator's power
cord into a 3-prong grounded outlet and push
the refrigerator into the final position.
Your refrigerator has two front leveling legs—
one on the right and one on the left. Adjust the
legs to alter the tilt from front-to-back or side-
to-side. If your refrigerator seems unsteady, or
you want the doors to close more easily, adjust
the refrigerator's tilt using the instructions
below:
1
Turn the leveling leg to the left to raise
that side of the refrigerator or to the right
to lower it. It may take several turns of the
leveling leg to adjust the tilt of the
refrigerator.
NOTE
A flare nut wrench works best, but an
open-end wrench will suffice.
Do not over-tighten.
2
Open both doors again and check to make
sure that they close easily. If the doors do
not close easily, tilt the refrigerator slightly
more to the rear by turning both leveling
legs to the left. It may take several more
turns, and you should turn both leveling
legs the same amounts.

Door Alignment

Both the left and right refrigerator doors have
an adjustable nut, located on the bottom hinge,
to raise and lower them to align properly.
If the space between the doors is uneven,
follow the instructions below to align the doors
evenly:
Use the wrench (included with the Owner's
Manual) to turn the nut in the door hinge to
adjust the height. Turn the nuts to the right
to raise the height or to the left to lower the
height.
The right refrigerator door does not have an
adjustable nut.
If the space between your doors is uneven,
follow the instructions below to align the right
door:
1
With one hand, lift up the door to raise at
the middle hinge.
2
With other hand, use pliers to insert the
snap ring as shown.
3
Insert additional snap rings until the right
door is aligned. (Three snap rings are
provided with unit.)
INSTALLATION 25