Samsung NX58K9850S Série Manuel D'installation page 15

Installation guide
SLIDE-IN CUTOUT
3"
1"min
Hatched Faces should
24" 3"
be flat and leveled.
35- / "
7
8
23 / "
3
16
25"
36 / "
3
16
A
29 15 / "
26 7 / "
16
16
A: Cabinet opening 30" (76.2)
IMPORTANT: If your cabinet have height over 36 4/5", this range cannot be
installed wirhout supporting unit like hard block.
Recommended locations for gas piping and electrical outlets
(For models NX58K9850S *, NX58K9852S * )
17 in x 9 in
(43.2 cm x 22.9 cm)
Gas Wall Area
Recommended area
for through-the-wall
and through-the-floor
connection of gas pipe
stub and shut-off valve.
FREESTANDING CUTOUT
3"
1 / "min.
25"
24"
2
3"
A
Recommended area
for 120 V electrical
outlet on rear wall
12 in
(30.5 cm)
CAUTION
You must use the rear filler kit to install the range in a freestanding cutout cabinet.
For more information, see "Optional rear filler kit" as shown below.
Optional rear filler kit
WARNING
Used to fill gap between the range back and wall. Adds a filler strip to the rear of
the range. This kit can only be used when the opening in the countertop is 25" deep.
NOTE
If the countertop depth is greater than 25", there will be a gap between the filler
kit and the back wall.
English 15