Hama Dashcam 30 Mode D'emploi page 16

12. Factory settings
To reset the Dashcam to the factory default settings, proceed as follows:
• Switch off the Dashcam as described in 7.2 Switching on/off.
• Press and hold [Reset] (4) for about 3 seconds using a pointed object.
• Alternatively, you can restore the factory settings as described in Section 9.3.5 Factory settings.
• All settings you made are deleted.
Note
• Resetting to the factory default settings can solve some problems and malfunctions.
• However, all settings made previously are permanently deleted.
13. Care and Maintenance
• Only clean this product with a slightly damp, lint-free cloth and do not use aggressive cleaning agents.
• Make sure that water does not get into the product.
14. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from
improper installation/mounting, improper use of the product or from failure to observe the operating
instructions and/or safety notes.
15. Technical Data
Max. resolution
Screen size:
Max. Resolution
Data format
Memory card
Power supply
Battery
14
89 x 48 x 35 mm
2.4"
Photo: 12 megapixels | Video: 1080i
Photo: JPEG | Video: AVI
Supports microSD memory cards up to 32 GB
Input: 12 V-24 V 0,5A; Output: 5 V
Input: 5 V 290 mA; Type: 3,7 V / LiPo;
Min. capacity: 130 mAh / 0.48 Wh
1A; cable length: 2 m
;