Switching On/Off; Inserting A Microsd Card; Video Mode; Photo Mode - Hama Dashcam 30 Mode D'emploi

7.2. Switching on/off

Note - Automatic switching on/off
If the Dashcam is connected to a power source by means of the vehicle charger, it automatically
switches on/off when the vehicle is started/switched off.
Note - Car battery
With some vehicles, it can happen that power continues to be supplied even though the ignition
has been switched off. In this case, switch off the camera manually to protect your car battery from
discharge.
Press and hold Power [

7.3. Inserting a microSD card

• Insert a microSD card into the microSD card slot (2) on the Dashcam.
• is shown on the display.
Note - Memory card full
Once the memory of the microSD card is full, the oldest video recording will be overwritten.
8. Modes

8.1 Video mode

• After switching on, the camera is in Video operating mode.
the screen.
• Video recording starts automatically when you switch on the device.
• Press [OK] (7) to stop/start video recording.
• The recording duration is displayed at the upper-left edge of the screen. The status LED (12)
alternates between red and blue.
Note - Night mode
Briefly press Power [

8.2 Photo mode

• Repeatedly press [MODE] (6) to activate Photo mode.
screen.
• Press [OK] (7) to take a picture.
8
] (10) for about 3 seconds to manually switch on/off the Dashcam.
] (10), during video recording to activate/deactivate Night mode.
appears at the upper-left edge of
appears at the upper-left edge of the