Mounting On A Wall - LG 22LN4510 Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Mounting on a wall

For proper ventilation, allow a clearance of
10 cm (4 inches) on each side and from the wall.
Detailed installation instructions are available from
your dealer, see the optional Tilt Wall Mounting
Bracket Installation and Setup Guide.
10 cm
(4 inches)
If you intend to mount the TV to a wall, attach Wall
mounting interface (optional parts) to the back of
the TV.
When you install the TV using the wall mounting
interface (optional parts), attach it carefully so it
will not drop.
1
Please, use the screw and wall mount interface
in accordance with VESA Standards.
2
If you use a screw longer than standard, the TV
might be damaged internally.
3
If you use an improper screw, the product
might be damaged and drop from mounted
position. In this case, LG Electronics is not
responsible for it.
4
Observe the VESA standards with respect to
screw mounting interface dimensions and
mounting screw specifications.
5
Please use VESA standard wall mount pad and
screws. Please use VESA standard as below.
784.8 mm (30.9 inch) and under
y
y
* Wall Mount Pad Thickness : 2.6 mm
* Screw : Φ 4.0 mm x Pitch 0.7 mm x
Length 10 mm
787.4 mm (31.0 inch) and above
y
y
VESA (A x B)
Standard screw
Number of screws
Wall mount bracket
(optional)
10 cm
(4 inches)
10 cm
(4 inches)
10 cm
(4 inches)
ASSEMBLING AND PREPARING
100 x 100
M4
4
RW120
CAUTION
Disconnect the power cord first, and then
y
y
move or install the TV. Otherwise electric
shock may occur.
If you install the TV on a ceiling or slanted
y
y
wall, it may fall and result in severe injury.
Use an authorized LG wall mount and
y
y
contact the local dealer or qualified
personnel.
Do not over tighten the screws as this may
y
y
cause damage to the TV and void your
warranty.
Use the screws and wall mounts that meet
y
y
the VESA standard. Any damages or injuries
by misuse or using an improper accessory
are not covered by the warranty.
NOTE
Use the screws that are listed on the VESA
y
y
standard screw specifications.
The wall mount kit includes an installation
y
y
manual and necessary parts.
The wall mount bracket is optional. You can
y
y
obtain additional accessories from your local
dealer.
The length of screws may differ depending
y
y
on the wall mount. Be sure to use the proper
length.
For more information, refer to the instructions
y
y
supplied with the wall mount.
15

Publicité

Chapitres

Table des Matières

Dépannage

loading

Table des Matières