Operating Instructions - Walter Surface Technologies BIO-CIRCLE MAXI 600C Manuel De L'utilisateur

OPERATING INSTRUCTIONS

The BIO-CIRCLE™ Parts Cleaning System is designed for the removal and
bioremediation of biodegradable oil and grease from ferrous and non-ferrous
parts and other washable surfaces. It is NOT recommended for cleaning other
non-biodegradable substances.
DO NOT INTRODUCE DISINFECTANTS, SOLVENTS, BRAKE FLUID, ENGINE
COOLANT, CHLORINATED, ACIDIC OR ALKALINE SOLUTIONS OR ANY
CLEANING SOLUTION OTHER THAN Bio-Circle L™ OR Bio-Circle Ultra™
INTO THIS SYSTEM. DO NOT ADD WATER.
1. Place parts to be cleaned into sink (H). Maximum load capacity is 220 kg/500
lbs. Do not plug drain to fill cleaning sink. Use optional Parts Washing Basket
(55-B 004) to contain small parts.
Note: Any parts susceptible to oxidation should not be left in the sink after
cleaning.
2. Position 3-way Control Valve (B) toward desired direction of solution flow.
Solution can flow through both the flexible faucet (A) and the flow-through brush
(C) simultaneously when the handle is positioned mid-way between the two.
B
A
7
C
G
L
F