Bio-Circle Technical Support; Warranty Policy - Walter Surface Technologies BIO-CIRCLE MAXI 600C Manuel De L'utilisateur

BIO-CIRCLE TECHNICAL SUPPORT:

Should you have any trouble with the operation of your BIO-CIRCLE Parts
Cleaning System, please refer to the section "TROUBLESHOOTING".
Should you require further assistance:
In Canada: CALL TOLL FREE 1-877-BIO-DRUM (1-877-246-3786)
In the USA: CALL TOLL FREE 1-888-246-2725
In Mexico: CALL TOLL FREE 01 800 263 6310
Visit us at: www.biocircle.com for additional information.

WARRANTY POLICY

All BIO-CIRCLE™ Parts Cleaning Systems and accessories are inspected and
tested before shipment and are warranted to be free from any defect in material
and faulty workmanship. Should any malfunction occur within one year from the
date of original purchase please call WALTER
(see page 17 for contact information).
Should a component examination reveal that the malfunction was caused by
defective material or faulty workmanship, WALTER will repair (or at our option,
replace) without charge. This warranty does not apply when; normal maintenance
is required, repairs or replacements have been made or were attempted by
anyone other than WALTER authorized service personnel, and does not cover
any damage caused by accidents, modifications, use of improper solutions,
accessories, abuse or misuse as well as continued use after partial failure. No
other warranty, written or verbal is authorized.
In no event shall WALTER be liable for any indirect, incidental or consequential
damages from the sale of the product. This disclaimer applies both during and
after the term of this warranty.
This warranty gives you specific rights. The provisions contained in this warranty
are not intended to limit, modify, take away from, disclaim or exclude any
warranties set forth in any provincial or state legislation. To the extent required
by law, the provisions in any provincial, state or federal legislation with respect to
warranties take precedence over the provisions in this warranty.
18