Walter Surface Technologies BIO-CIRCLE MAXI 600C Manuel De L'utilisateur page 10

5. The bioremediation process requires a favorable environment at all times,
even when the unit is not in use. Always keep the solution level topped-up
and the unit turned on to maintain proper temperature and oxygen supply
through the built-in air pump and heater.
6. As with all parts cleaners, excess grease and oil should be disposed of prior
to cleaning. Do not use this unit as a waste dump.
7. Inspect the grated receptacle (G) daily, it should be emptied of accumulated
solid waste and disposed of outside the parts washer in order to extend the
life of the solution.
8. A magnet is located underneath the grated receptacle (G) to separate all the
ferrous particles, thus enhancing the bioremediation process. The magnet
should be cleaned periodically with a clean rag to maintain its efficiency and
ensure rapid draining of the sink.
9. This unit is equipped with a damper located underneath the grated
receptacle (G) to slow down evaporation. If too much evaporation occurs,
verify that the damper moves freely.
10. The BIO-CIRCLE™ Parts Cleaning System is designed for removing oil and
grease from parts and then remediating those substances. Any other use of
this system, such as dumping waste oil, is not recommended and will cause
damage to the system.
11. For stubborn grime and other hard to clean spots, first spray or soak parts
using WALTER OMNI™ (53-X 003, 500ml trigger sprayer) prior to cleaning
with Bio-Circle L™ or Bio-Circle Ultra™ solution.
DO NOT USE ANY OTHER TYPES OF CLEANERS, as they will reduce or
prevent the bioremediation process and cause malfunctions to the unit. Also,
adding water will considerably reduce the bioremediation process as well as
the solution's ability to clean.
12. The built-in thermostat has been factory set to maintain an ideal environment
for the bioremediation process as well as preventing skin burns to the user
and damage to the pump. Do not attempt to alter this unit in any way.
13. Condensation will accumulate underneath the sink top. This is normal due to
the temperature of the cleaning solution. Always ensure that the sink is
closed properly and that the gasket underneath the sink is not damaged to
prevent excessive evaporation.
Note: After a power interruption, the machine will restart automatically,
except for the cleaning pump.
9