Start-Up; Changing The Radio Channel Of The Heating Control - Villeroy & Boch Heating Control Manuel D'utilisation

2

Start-up

• The Heating Control and the receiver do not need to be taught.
They are already both set to radio channel 1 at the factory and are ready for operation.
Only in specialist cases is it necessary to change the radio channels on the receiver and the Heating Control.

2.1 Changing the radio channel of the Heating Control

• An Heating Control and receiver that have not been set to the same radio channel
cannot communicate with each other!
This process is needed if you want to pair a second Heating Control with a receiver which has been set to a
different radio channel than radio channel 1. Proceed as follows:
1. Hold the and
> The signal LED on the Heating Control starts to flash.
2. Wait until the flashing stops and then release both buttons.
> The signal LED now starts to flash slowly for 5 seconds.
3. Within these 5 seconds, briefly press the
> Then comes the radio channel selection step: The signal LED flashes once for radio channel 1, twice for
radio channel 2, and so on. This sequence of flashing is repeated three times.
[.....]
[.....]
[.....]
4. Confirm the required radio channel by pressing the
> The Heating Control confirms the change of radio channel by flashing quickly four times.
www.villeroy-boch.com // V 1.0 // 21.02.2017 // Heating Control DE/EN/FR/NL/RU
buttons down.
key.
Radio channel 1
Radio channel 2
Radio channel 3
Radio channel 4
button during the pause after the signal flash.
3 x
9