Changing The Radio Channel Of The Receiver; Operation; Activating / Deactivating Heating Control - Villeroy & Boch Heating Control Manuel D'utilisation

2.2 Changing the radio channel of the receiver

• All receivers that are not to have their radio channels changed should be disconnected
from the power supply.
• The receiver's radio channel is changed via the Heating Control. The Heating Control
being used automatically uses the same radio channel as the receiver.
This process is needed, for example, if two systems are transmitting on the same channel and unwanted
interference occurs. In this case, you can switch the Heating Control and receiver to a different channel.
1. Hold the and
> The signal LED on the Heating Control starts to flash.
2. Wait until the flashing stops and then release both buttons.
> The signal LED now starts to flash slowly for 5 seconds.
3. During these 5 seconds, press the
> Then comes the radio channel selection step: The signal LED flashes once for radio channel 1, twice for
radio channel 2, and so on. This sequence of flashing is repeated three times.
[.....]
[.....]
[.....]
4. Confirm the required radio channel by pressing the
> The Heating Control confirms the change of radio channel by flashing quickly four times.

3 Operation

3.1 Activating / deactivating Heating Control

Hold the 4 key on the Emotion Control down for at least 5 seconds in order
to activate / deactivate the Heating Control's functions.
> Activating: The mirror heater status LED flashes 4x quickly.
> Deactivating: The mirror heater status LED flashes 4x slowly.
10
buttons down.
key and hold it down until the signal LED goes out again.
Radio channel 1
Radio channel 2
Radio channel 3
Radio channel 4
button during the pause after the signal flash.
www.villeroy-boch.com // V 1.0 // 21.02.2017 // Heating Control DE/EN/FR/NL/RU
3 x
1
2
3
4
Emotion Control Heating Control