Connect The Cables - Axis Q1755-E Guide D'installation

Page 10

Connect the cables

1. Optionally insert an SD memory card (not included) into the SDHC (Secure Digital High
Capacity) card slot. A standard or high capacity SD card is required to store images locally in
the camera.
2. Optionally connect external input/output devices. See page 18 for information on the terminal
connector pins. Prepare the cables with gaskets, see
route the cables through the cable holes into the bottom cover and to the camera.
3. Connect the camera to the network using a shielded network cable. Use the network connector
(PoE IN ) on the bottom cover. The network cable and the I/O cable between the bottom cover
and the camera are already connected at delivery.
4. Check that the indicator LEDs indicate the correct conditions. See the table on page 21 for
further details.
AXIS Q1755-E Installation Guide
Prepare the network cable,
Network cables
I/O cable
Bottom cover
Network connector (PoE OUT,
connected at delivery)
Cable holes
Network connector (PoE IN)
LED indicator
Arctic Temperature Control switch
(disabling not recommended)
Alarm output
(connected at delivery)
on page 8, and