Charging The Battery Pack - Dirt Devil DUPLEX Mode D'emploi

Masquer les pouces Voir aussi pour DUPLEX:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 40
3 Before first use

3.4 Charging the battery pack

WARNING:
Danger of injury due to incorrect charging!
Only use the power supply unit supplied
with the appliance for charging.
7
8
9
30
ATTENTION:
Make sure you charge the batteries fully
and then discharge them fully before using
for the first time. Otherwise the battery
pack's service life would be reduced.
NOTE:
The battery pack is not charged when deliv-
ered. The battery pack must be charged
before working with the appliance. The first
charge takes about 16 hours.
NOTE:
You can only charge the battery pack when
it is installed. Make sure that that appliance
is switched off. If the appliance is switched
on, the battery pack cannot be charged.
1. Make sure that that appliance is switched
off (position '0').
2. Insert the power supply unit into the sock-
et on the back of the appliance (Fig. 7).
3. Connect the power supply unit to a socket
(Fig. 8) that carries the same voltage as
that indicated on the power supply unit's
type plate.
The charging indicator light begins to
shine red (Fig. 9).
4. Charge the battery pack for approx. 16
hours, until the charging indicator light
goes out (Fig. 9).
5. If the charging indicator light is no longer
illuminated, first pull the power supply unit
out of the socket and then out of the appli-
ance or battery pack.
NOTE:
Only recharge the appliance after use if the
brush roller will no longer turn even though
the battery pack is inserted properly. Sub-
sequent full charging cycles will take
approx. 16 hours. Depending on the
remaining charge, it could be much shorter.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Duplex m668

Table des Matières